1. Run an extension cord of adequate length to reach the center of the dome from a wall outlet
2. Turn on a light source in the dome
3. Wheel the projector inside the dome
4. Undo the case clasps on the lid
- Flip the butterfly latch out
- Twist the latch counter-clockwise until the clasp pops open
5. Remove the lid
6. Remove your accessories from the storage bin
7. Plug the case into your power source
- Plug the case power cord into the case power port.
- Plug the other end of the case power cord into your extension cord.
Don't be alarmed if the power cord included in your StarLab case doesn't look exactly the same as the image above. Your cord may have the L-shaped angled plug as above, or it may be a straight plug that is like the end of an extension cord.
8. Turn on the case power switch
9. Turn on the projector power button
10. Center your projector in the dome using the centering procedure
11. Remove the lens cap and place it in the storage compartment
12. Turn on the laptop and speaker
13. Plug in the USB-C cord to the computer
14. Launch the Starry Night software
15. Focus and level the projector if needed
